Comandos para Realtek RTD2842

Comandos disponibles para el SOC RTD2842 de Realtek, con los que podrás interactuar para poder resolver problemas y averías en las main que montan este SOC.

MARCA:
MODELO:
MÓDULOS: ,
SECCIÓN:
helpavb     - Provides commands for testing Android Verified Boot 2.0 functionality
bdinfo  - print Board Info structure
bootr   - boot realtek platform
cp      - copy file from dos filesystem into a dos filesystem
cp_ddts - CP ddts test
dcache  - enable or disable data cache
diseqc  - DISEQC command description/usage
dssinfo - print dss
env     - environment handling commands
facro   - FACTORY read-only sub system
factory - FACTORY sub system
fatinfo - print information about filesystem
fatload - load binary file from a dos filesystem
fatlock - lock a dos filesystem
fatls   - list files in a directory (default /)
fatunlock- unlock a dos filesystem
fatwrite- write file into a dos filesystem
fdisk   - Create logical drives on the physical drive
fw      - select the specific firmware config from hikeentv
go      - start application at address 'addr' or start running fw
help    - print command description/usage
hwmonitor- hw monitor setting
i2c     - i2c test
icache  - enable or disable instruction cache
irda    - irda - select irda protocol
kboot   - start kboot function
layout  - show flash layout
loady   - load binary file over serial line (ymodem mode)

logbuf  - rtd logbuffer sub system
loglevel- set console loglevel to env and bootcode will pass this value to kernel
ls      - RenaRead a directory item
md      - memory display
mkdir   - Create a sub-directory
mkfs    - Create an FAT volume on the logical drive
mmc     - MMC sub system
mtest   - simple RAM read/write test
mv      - Rename/Move a file or sub-directory
mw      - memory write (fill)
panel   - select the specific panel config from panel array
ping    - send ICMP ECHO_REQUEST to network host
print   - print	- turn on/off print message.

pwm     - PWM command description/usage
pwminvert- set the pwminvert [on|off]

reset   - Perform RESET of the CPU
rm      - Remove a file or sub-directory
rtkmmc  - RTK MMC direct function

saveenv - save environment variables to persistent storage
showvdq - showvdq - show vdq info
sleep   - delay execution for some time
spanel  - spanel - select panel

stat    - stat a dos file/directory
swu     - FW upgrade sub-system
swuu    - FW upgrade sub-system
tftp    - download image from TFTP server
tftpput - TFTP put command, for uploading files to a server
timelog - set the bootloader time log [on|off]

tuner   - tuner - select tuner model;
uart2rbus- uart2rbus [off|on|on_0|on_1|on_2]

usb     - USB sub-system
vsyncapad- vsyncapad [I2S|VGA]

wdt     - watch dog enable/disable
write   - write file into a dos filesystem

Ejemplos de utilización:

Ver en que puerto USB está conectado un pendrive:

Realtek> usb dev

Ejemplo de resultado donde vemos que lo tenemos en el puerto 0, esto es importante para luego poder hacer ciertas operaciones y que hay que indicar el puerto USB:

USB device 0: Vendor: Kingston Rev: 1.00 Prod: DataTraveler 2.0
            Type: Removable Hard Disk
            Capacity: 30632.0 MB = 29.9 GB (62734336 x 512)

Deja un comentario

Este sitio usa Akismet para reducir el spam. Aprende cómo se procesan los datos de tus comentarios.